Edited: March 31, 2026
This information is applicable to Cricut Explore 4 (and prior) and Cricut Maker 4 (and prior) models, and Cricut Venture machines.
The accessory adapter is pre-installed in accessory Clamp A. However, if you need to remove the accessory adapter for replacement or use of Cricut Permanent Markers, 2.5mm, follow these steps:
Note: It’s not necessary to remove the accessory adapter in order to insert most pens or the scoring stylus. Only the Cricut Permanent Markers, 2.5mm and Auto Cut-Off Blade (for Cricut Venture) require removal of the accessory adapter.
- Open accessory Clamp A.
- Place your thumb underneath the accessory adapter and apply pressure upwards while pushing down on the clamp. The adapter will pop out of the accessory clamp.
- To re-install the accessory adapter, place a finger underneath clamp A to stabilize it as you reinsert the accessory adapter from above.
- Apply some pressure while inserting the adapter. The adapter will snap into place when properly installed.
Cricut Venture
Cricut Explore/Cricut Maker machines
Note: The accessory adapter for the Cricut Explore One is different than the accessory adapter for other Cricut Explore machines, Cricut Maker machines, and Cricut Venture machines. In Cricut Explore One, the accessory adapter is switched with the blade housing when the user wishes to write or score. For other Cricut machines, the accessory adapter is housed in its own clamp, separate from the blade housing.
| Model | Compatible Accessory Adapter |
|---|---|
| Explore One | |
Venture Explore 4 Maker 4 Explore 3 Maker 3 Explore Air 2 Maker Explore Air Explore |